| |
Only $84.50!
$40 for Each
Additional Unit
Ask us about our
service contracts!
 |
|
1. Check refrigerant temperatures and pressures for proper levels.
2. Measure compressor amp draw.
3. Test high voltage out door disconnect box.
4. Inspect and tighten high voltage connections.
5. Level and calibrate the thermostat.
6. Inspect refrigerant fitting for leaks.
7. Lubricate indoor and outdoor motors.
8. Check wiring at furnace for loose connections.
9. Tighten blower bolts and connections.
10. Inspect and clean or replace air filter.
11. Inspect and adjust blower belt if applicable.
12. Inspect condensate to ensure drain is clear.
13. Test temperature split between return and supply ducts.
14. Check clearance around condenser to protect it from trees and shrubs.
15. Clean condenser coil.
16. Scrub condenser surface.
17. Tighten screws on condenser and check balance.
18. Check compressor noise level.
19. Inspect breaker for condensing unit.
20. Tighten refrigerant access fittings.
21. Visually inspect inside ducting for dirt or mold.
22. Inspect ducting and fittings for air loss.
|
